Stuff you Must Consider Before Applying Custom

When you have made your custom bumper stickers, the next step is applying it to your car, but before you do, here are few tips you must consider.

Contoured surfaces, you should be aware that bumpers are not flat, there are significantly of concave or convex curves on it, so tendency of lifting often occurs when you applying your custom bumper stickers, to avoid this problem try to use film which has less thickness, some of the manufacturers give 2 mil since their recommendations, but you should be more carefull when you choose less thickness, these films are easy to tear and once you peel this off for repositioning purpose, film will stretch easily.

Age of custom bumper stickers, people use custom bumper stickers for many purposes, marketing, campaign or just for celebration.one you have decided the age of your custom bumper stickers, it ought to be followed by adhesive considerations. Prone to sticker less than a single year of age you have to determine lower adhesion usually in the selection of 2 to 5 pounds/inch [0.4-0.9 kg/cm] peel-back adhesion makes it possible for the film to be removed remove easily without the aid of heat and chemicals and whitout adhesive residue. However, its lower may lead to some lifting of film in areas where the film is incredibly stretched.

Clean the surfaces, remember . today we try to utilize a custom bumper stickers, first need to consider that our bumpers are contaminated especially from dirty, oil and dead insects. Wash your bumpers with liquid dishwashing detergent, per gallon of lukewarm water, and rinse it with water, dry the surface thoroughly with clean, lint-free paper towels, you may use heat gun to accelerate the dehydrating.

Please note : moisture prevents the adhesive of your custom bumper stickers from adhering correctly, can cause bubbles and can freeze in cold parts of the country.

Wipe the surface again with a solvent based cleaner through : saturate a clean paper towel, wipe it with lint-free paper towel before the solvent evaporate of one's substrate, make sure the substrate is perfectly dry, if necessary use a heat gun to dry any retained solvents. Finally apply your custom bumper stickers immediately.

Please note : car wax can greatly reduce graphic adhesion. Solvent based cleaners must use to thoroughly remove any wax scum. Alcohol based cleaners do not remove wax as effectively.

find more usefull informations only at http://www.decalspaint.com